374
Peripherals
Peripherals - Others
KissBox Setup
The KissBox editor software which comes with the product has to be installed on the laptop/PC
being used to set the IP address. Install the “KissBox_Editor_Win_11_0_0”.
Unplug the laptop/PC from any network being used (this is to stop any network IP address
conflicts).
Configure the laptop/PC so that it is on the Grass Valleye network as the KissBox, as shown
below. Click on “OK”. The network settings can be found in the “Control Panel\Network and
Internet\Network and Sharing Center\Local Area Connection\Properties\Internet protocol
Version 4(TCP/IPv4)”
Start up the KissBox Editor software, then in the “Add KissBox manually” area of the KissBox
Editor menu, type in the IP address of the KissBox and click on “Add Box”. The menu will now
look like the one below:
Change the IP setting in the “Network Configuration area of the menu to match the required IP
network and click on “Upload”. Then re-start the KissBox.
Change the laptop/PC network configuration back to the required network. Type the new
KissBox IP address into the “Add KissBox manually” area of the menu, then click on “Add Box”.
You will now see the updated network configuration.
To Next Page
Loading...
