377
Masterpiece
User Manual
You should be able to slide faders via the Visual or Fader Module and see corresponding faders
move on Yamaha Audio Mixer for communication test.
Parameters:
Slot - this relates to the protocol setup slot that the Yamaha protocol was assigned to in Eng
Config - Protocols.
Module - this relates to the GIU on the Masterpiece control surface. The first being 1-8 which
relates to the faders on the MAV-Audio Fader module.
Fader - relates to the Faders on the selected (Module) MAV-Audio Fader module.
Button - this selects one of the 4 types of buttons above the fader sliders in the menu. The
buttons are:
• Cut - this will cut the fader On or Off.
• PFL - (Pre Fade Listen), this displays if the “PFL” function is set or available to use. PFL allows
the user to listen to the channel's audio at a point before the fader takes effect.
• AVFO - (Audio Follow Video Override), this is an audio sources that is associated with a
video source which can be linked in the Fader Map.
• Learn - this allows the button to copy a button function from the audio mixer.
Source - this is the Protocol Source that is mapped to the audio mixer's Inputs, Aux, Buses etc.
(see the Protocol Source map table at the back of this document).
Type - this sets the type of audio fader control in the menu, see below (Unassigned means that
no fader type is selected).
To Next Page
Loading...
