22
Initial Setup Menus
Log into the System
after a significant panel change occurs (a delegate is changed, a button map is
loaded/unloaded, a panel config file is loaded etc).The control surface also saves its state
before logging out.
There are three different states indicated with the “HDD” symbol:
• Red HDD = the hard disk is being written to
• Green HDD = the hard disk is reading
• Orange HDD = the hard disk is mounting
Touch the {Save Now} button and a dialog box is displayed asking if you want to “Create Auto
Save Switcher State”.
Touch the {Load Now} button and a dialog box is displayed asking if you want to “Load Auto-
Saved Switcher State. The dialog box also gives you the option to enable or disable Eng, User
and Panel configs, DMEM and Stores.
The {Clear Auto-Save State} button will clear the auto-save state buffer.
In the center of the screen is the Panel Auto-Connect box (5). From here the system can be set
to automatically connect to a preferred mainframe each time the system is switched on and
boots up. Press the {Preferred Mainframe} button. The next time the system is switched on, at
boot up, the system will go straight to the Connected to menu. The {Last Mainframe} button
sets the mainframe to start-up as the last mainframe that the system was being used as. Press
the {Disabled} button to disable these functions.
To Next Page
Loading...
Need help?
General
