SmartPAC 2 with WPC Integration 1126800
Installing SmartPAC 2 and WPC Chapter 2 page 127
Part 7 – Perform Checkout Tests
DANGER
!
INCORRECT INSTALLATION
• Perform the necessary checkout tests according to the instructions in this manual.
• Correct any malfunctions before running the press.
• Ensure that all procedures are performed by qualified personnel.
Failure to comply with these instructions will result in death or serious injury.
DANGER!
INJURY DURING TESTING
Keep all personnel away from the press during testing.
Ensure that there is no die or other tooling in the press during testing.
Failure to comply with these instructions will result in death or serious injury.
NOTICE
Use the “test tool” you created and loaded during setup procedures, page 103.
NOTICE
For help in using SmartPAC 2, see: Chapter 3 – Keyboard and Displays
Chapter 4 – Initialization mode
Chapter 5 – Program mode
Chapter 6 – Run mode
Before you operate your press, you must perform the tests in this section to verify that your
Wintriss Clutch/Brake Control System is installed and set up correctly. See the list of tests
on the next page. Contact Wintriss Tech Support if you cannot correct a problem that occurs
during testing.
You will need the press to top stop in inch mode during these tests, so make sure there is no
connection to pin #13 on the WPC control board. (See information about disabling top stop
in Inch, page 367)
To Next Page
Loading...
Need help?
General
