SmartPAC 2 with WPC Integration 1126800
SmartPAC Preventive Maintenance Appendix B page 449
(PM) Monitor
ITEM ALERT EVERY
USE THE CURSOR KEYS TO MAKE
SELECTION. PRESS ENTER TO SELECT
RESET WHEN DONE.
NEW ITEM
100 DIE CHANGES
in this example, we
entered "slide
adj. motor" and
set it to alert at
100 die changes
YOUR PRESS NAME
PM MONITOR
SLIDE ADJ. MOTOR
Figure B - 13. Example
9. To set more PM items, repeat steps 1 through 8. When you are completely done
initializing the PM items, press RESET to return to the main Initialization mode.
10. You can now go to the Run mode to view the PM Monitor status conditions. There is no
PM information to set in SmartPAC's Program mode. You made all the required settings
in the Initialization mode.
To Next Page
Loading...
