EasyManuals Logo

Honeywell SmartPAC 2 User Manual

Honeywell SmartPAC 2
522 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #438 background imageLoading...
Page #438 background image
1126800 SmartPAC 2 with WPC Integration
Page 416 Chapter 7 SmartPAC 2 Fault Messages
Fault message for red sensors "This N/C sensor is open"
Explanation: A red sensor has actuated (is open to ground). When this message appears,
the angle where the condition was detected is also listed shown on the
LCD display.
Remedy: Check for the press or equipment malfunction that the sensor was
supposed to detect. If none has occurred, check for a malfunctioning
sensor. Check for loose or detached wiring at the remote connection box
or controller. Check for a severed wire from the sensor to the RCB or
controller.
Miscellaneous Fault messages
"Maximum press speed exceeded"
Explanation: This message is generated when the press is running at a speed greater
than the maximum limit set at SmartPAC 2.
Remedy: After clearing the error, either run the press at a slower speed, or adjust the
maximum limit set at SmartPAC 2. Refer to Chapter 4.
"Minimum press speed exceeded"
Explanation: This message is generated when the press is running at a speed less than
the minimum limit set at SmartPAC 2.
Remedy: After clearing the error, either run the press at a higher speed, or adjust the
minimum limit set at SmartPAC 2. Refer to Chapter 4.
"stop"
Explanation: This message is only generated when SmartPAC 2 is communicating with
PACNet Computerized Pressroom Reporting software. The user at the
computer has sent a top stop command to that SmartPAC 2. When this
occurs, SmartPAC 2 in turn stops the press.
Remedy: Because this condition was generated by someone at the computer, it is
important to investigate the reason why the stop command was issued. A
problem may be present. Check with personnel before proceeding. After
the situation is clear, press RESET to continue.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell SmartPAC 2 and is the answer not in the manual?

Honeywell SmartPAC 2 Specifications

General IconGeneral
BrandHoneywell
ModelSmartPAC 2
CategoryControl Unit
LanguageEnglish

Related product manuals