1126800 SmartPAC 2 with WPC Integration
Page 360 Chapter 6 SmartPAC 2 Run Mode
Figure 6 - 28. Load Tool Warning Box
• If you want to load the tool, press ENTER. A message appears, saying “Tool
Number Is Being Loaded” while SmartPAC 2 loads the tool. The display returns to
the main Run menu and the tool number you just loaded appears in the status box.
• If you do not want to load the tool, press RESET. The display returns to the main
Run menu.
NOTICE
If you tried to load the tool, and got an error message instead of the “Tool Number Being
Loaded” message, go to Chapter 7 and find the section describing that error message.
Follow the instructions there for correcting the problem. If the error message is not described
there, or you cannot fix the problem, contact Wintriss Tech Support, and be ready to provide
some important information to expedite a resolution to the problem. Please supply: product
name (e.g. SmartPAC 2 standard); installed options (e.g. DiProPAC, ProCamPAC, etc.); and
firmware version number (e.g. Vs. 2.00). You can determine the last two items, by going into
"Installed options" in the Initialization mode (see Chapter 4 for details).
For HELP press the HELP key located at the center of the cursor (arrow) keys.
To Next Page
Loading...
Need help?
General
