Honeywell SmartPAC 2 - Figure 5

To Next Page

To Previous Page

SmartPAC 2 with WPC Integration 1126800

SmartPAC 2 Program Mode Chapter 5 page 277

Figure 5 - 4. Tool Manager

NOTICE

To e-mail a copy of this screen, see “Screen Capture,” page 199.

NOTICE

Tool Manager lists the tools differently, depending on how you have set Tool Number mode

in Initialization (page 206).

Numeric mode: Tools listed by tool number

Alpha-numeric mode: Tools listed by tool name

The example above is “numeric,” listed by tool number.

Refer to the pages indicated for instructions for performing the following procedures:

• Load an Existing Tool, page 278

•

Delete a Tool, page 279

• Tool Template, page 280

• Create a New Tool, page 281

• Copy an Existing Tool, page 282

• Change Settings for an Existing Tool, page 282

For HELP press the HELP key located at the center of the cursor (arrow) keys.

Honeywell SmartPAC 2 - Figure 5 - 4. Tool Manager