EasyManuals Logo

Honeywell SmartPAC 2 User Manual

Honeywell SmartPAC 2
522 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #347 background imageLoading...
Page #347 background image
SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Run Mode Chapter 6 page 325
Part 1 – Using SmartPAC 2 in Run Mode
How to Enter and Exit Run Mode
NOTICE
Load a tool number before entering Run mode. See next section.
Find instructions for running the press at the end of this chapter, starting on page 364.
To Enter Run Mode To Exit Run Mode
Turn the Program/Run key toward RUN.*
To go to Program mode:
Turn the Program/Run key toward PROG.*
* If you turn the key and nothing happens, press RESET repeatedly until the SmartPAC 2 changes modes. To
prevent this problem, before you turn the Program/Run key, make sure SmartPAC 2 is in the main (or top) menu for
the mode it is in. If it is not, press RESET repeatedly until the main menu appears.
NOTICE
SELECT = HIGHLIGHT + ENTER
When this manual says “select,” it means highlight the item and press ENTER.
For HELP press the HELP key located at the center of the cursor (arrow) keys.
Load A Tool Number Before Switching to Run Mode
A tool number must be loaded before SmartPAC 2 will allow the press to run. If no tool
number is loaded, you cannot switch from Initialization mode or Program mode to Run
mode.
If you switch to Run mode without a tool number loaded, you will get this error message on
your screen:
Figure 6 - 3. No Tool Loaded Warning

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell SmartPAC 2 and is the answer not in the manual?

Honeywell SmartPAC 2 Specifications

General IconGeneral
BrandHoneywell
ModelSmartPAC 2
CategoryControl Unit
LanguageEnglish

Related product manuals