SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Program Mode Chapter 5 page 315
TOOL INFORMATION
(PROGRAM – TOOL INFORMATION)
NOTICE
• Tool Information serves only as a convenient place to record information about the tool. It
does not control any aspect of press operation.
• This feature is not available if you have the optional PLC interface installed.
Select “Tool Information” under the main Programming menu (Figure 5 - 3) to record useful
information about the tool you are programming. See “Tool number information” in
Chapters 4 to set up the information items.
ENTER YOUR PASSWORD
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSON KEYS TO
INCREASE/DECREASE. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
60599
If this display appears, you need to enter the general password to access these settings. Password
access is set under Security Access in Initialization mode. See “Security Access” in Chapter 4,
page 251.
You will see a display similar to the following:
Use cursor
keys to
move
selection
bar to
desired
item. Press
ENTER.
TOOL NUMBER INFORMATION
PASS LINE HT IN
STRAIGHTENER 4.25 IN
HYD. OVLD. 100 TONS
PRESS SPEED 65 SPM
CONVEYOR NO
PART LUBE YES
MEMO BOX
MEMO LINE 1
CAREFULLY CHECK
DIE PLACEMENT MEMO LINE 2
USE CURSOR KEYS TO CHOOSE THE VALUE YOU
WANT TO CHANGE. PRESS THE ENTER KEY TO
CHANGE IT. PRESS RESET KEY WHEN DONE.
F4
F5
4.50
Figure 5 - 39. Tool Number Information Screen
To Next Page
Loading...
