SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Run Mode Chapter 6 page 355
TOOL INFORMATION (Optional)
(RUN – TOOL INFORMATION)
NOTICE
• Tool Information serves only as a convenient place to record information about the tool. It
does not control any aspect of press operation.
• This feature is not available if you have the optional PLC interface installed.
• If SmartPAC 2 is connected to PACNet computerized pressroom reporting, “Display the Next
Tool” may appear at function key F4. See the PACNet manual for more information.
If you have this option, select “Tool Information” from the Run menu (Figure 6 - 1) to
change the information about the tool you are using. (See “Tool Information” in Chapter 5.)
You will see a display similar to the following.
F1
F2
F3
F4
F5
F6
F7
F8
Figure 6 - 22. Tool Information Screen
“Display the Next Tool” available only with PACNet Software
ARE YOU LOCKED OUT?
Access to changing the information on this screen may be limited to Program mode or may
require a password. The security access settings in the Initialization menu determine when
changes can be made. See “Security Access” in Chapter 4, page 251.
To enter information about the items:
1. Select the desired item. A screen overlay appears in which you can enter the appropriate
value. For Yes/no items, enter 0 (zero) for NO, and 1 (one) for YES.
2. Enter text into the memo box, by pressing F5 for the first line, and F6 for the second
line. A screen overlay appears that enables you to enter fifteen characters of numbers
and alphabetic text for each line. When you complete each line, press F6 to accept it.
3. When you have finished entering information into the tool number information screen,
press RESET to return to the main Programming menu.
To Next Page
Loading...
Need help?
General
