Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Initialization Mode Chapter 4 page 217
F1
F2
F3
F4
F5
F6
F7
F8
Figure 4 - 11. Global Cams, Select Cam Channel
Asterisk (*) Indicates Global Cams
3. Select the cam you want to program. The following screen appears.
Figure 4 - 12. Global Cam Timing Type
4. Select the type of cam timing you want to set. Set the timing according to the
instructions at “CAM SWITCH,” page 302, in Chapter 5.
5. When you have completed setting the timing, press RESET.
NOTICE
If you set or change global cams while a tool is loaded, you must reload the tool to make the
global cams take effect.

Honeywell SmartPAC 2 Specifications

General

Brand	Honeywell
Model	SmartPAC 2
Category	Control Unit
Language	English