Honeywell SmartPAC 2 - Figure 5 - 15. Advanced Counter Mode

SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Program Mode Chapter 5 page 291
ADVANCED COUNTER MODE SELECTIONS
PARTS MADE PER EACH STROKE = 1
STROKES TO MAKE EACH PART = 1
1
Figure 5 - 15. Advanced counter mode
2. Highlight the item you want to set. Press ENTER. A box appears on the screen, as
shown below.
ADVANCED COUNTER MODE SELECTIONS
PARTS MADE PER EACH STROKE = 1
STROKES TO MAKE EACH PART = 1
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSOR KEYS TO
INCREASE/DECREASE. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
1
1
Figure 5 - 16. Setting Parts/Stroke or Strokes/Part
3. Use the keypad or cursor keys to change the number of parts/stroke or strokes to make
each part. Press ENTER. Press RESET to return to Counter Mode Selections.