Glossary page 461
SmartPAC 2 with WPC Integration 1126800
Glossary of Terms
ACTS also known as "Auto Compensated Top Stop"; specifically
designed for variable speed presses; WPC assumes that the Top
Stop Angle (programmed previously) is set at the slowest speed
resulting in the shortest stopping angle (see Chapter 4)
actuation change in state or condition
actuation angle sensor's on and off angle; dwell
actuation block square indicating a sensor’s actuation state on the "Show
sensors" display in Run mode which indicates that a sensor is
actuated.
ANSI stands for American National Standards Institute; U.S.
clearinghouse and coordinating body for voluntary standards
activity on the national level
auto advance equal to the number of degrees of advance per 100 RPM
increase in press speed
auto advance equal to the number of degrees of advance per 100 RPM
increase in press speed
Auto Carry-up another name for operator station mute; bypasses the operator
station during the non-hazardous portion of the stroke; when the
operator releases his hands from the palm buttons, the press
automatically completes the stroke and stops at TDC (see
Chapter 4)
auto enable by sensor die protection mode where the die protection module
automatically enables an individual sensor after a designated
number of strokes
auto enable by tool die protection mode where the die protection module
automatically enables all sensors in a tool after a designated
number of strokes
Automatic Single Stroke allows the operator to automate a manual press using a feeding
device or robot
batch counter can be set to either top-stop the press or signal programmable
limit switch (PLS) outputs when its preset is reached
To Next Page
Loading...
Need help?
General
