EasyManuals Logo

Honeywell SmartPAC 2 User Manual

Honeywell SmartPAC 2
522 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
1126800 SmartPAC 2 with WPC Integration
Page 72 Chapter 2 Installing SmartPAC 2 and WPC
Installing SmartPAC 2 as a Panel Mount
This section explains how to install your SmartPAC 2 as a panel mount. After you complete
this section, refer to the remainder of the chapter to complete your installation.
Standard Enclosure Versus Optional Panel Mount
SmartPAC 2 is available either with an enclosure or as a panel mount. The panel mount can
be mounted from the inside or outside. Be sure to allow at least 6” (152 mm) of clearance
behind the panel mounting plane to allow enough room for the electronics.
Preparation for Mounting SmartPAC 2 Using Your Enclosure
To prepare for mounting SmartPAC 2 using your panel enclosure, follow these steps:
1. Determine a convenient place to mount SmartPAC 2 into your panel enclosure. Ideally it
should be close to the press control so operators and setup personnel can easily see the
readouts and reach the keyboard.
2. Cut out a hole in your panel enclosure, and drill and tap twelve holes for #10-32 screws.
Refer to Figure 2 - 19 for mounting and “cutout” dimensions.
3. Mount SmartPAC 2 in your panel and access the wiring connections from the back.
4. Refer to the remainder of this chapter to complete the entire installation.
Go to “Wiring between WPC and SmartPAC,” page 74, to start wiring your SmartPAC 2.
When the installation is complete, you will mount SmartPAC 2 into your panel enclosure.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell SmartPAC 2 and is the answer not in the manual?

Honeywell SmartPAC 2 Specifications

General IconGeneral
BrandHoneywell
ModelSmartPAC 2
CategoryControl Unit
LanguageEnglish

Related product manuals