SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Run Mode Chapter 6 page 343
View Global Cam Summary
(RUN – CAM SWITCH – F5-VIEW GLOBAL CAM SUMMARY)
NOTICE
Find instructions for running the press at the end of this chapter, starting on page 364.
NOTICE
If you set or changed global cams while a tool was loaded, you must reload the tool to make
the global cams take effect.
You can also view a summary of the Global cams by pressing F5-“View Global Cam
Summary.” A screen similar to the following appears, listing the channel number, cam
name, type and ON/OFF or time setting.
F1
F2
F3
F4
F5
F6
F7
F8
Figure 6 - 16. Viewing Global Cams
NOTICE
To e-mail a copy of this screen, see “Screen Capture,” page 199.