Honeywell SmartPAC 2

To Next Page

To Previous Page

SmartPAC 2 with WPC Integration 1126800

SmartPAC 2 Keyboard, Displays Chapter 3 Page 177

and Operating Modes

• To key in numbers: Use the number keys to place the number in the box; then press

ENTER.. SmartPAC 2 will accept the number and close the entry box.

• To key in letters: Use the cursor keys to highlight the desired letter, space or symbol;

then press ENTER to accept that letter. In the Alphanumeric mode box, Figure 3 - 7, you

can press the F2 key to change between upper- and lower-case letters. To accept an

alphabetic or alpha-numeric entry, press function key F6. For more information about

the alphanumeric mode, see Chapter 4.

• To cancel your selection, in either case, press RESET.

Clear Key

CLEAR

ENTER

RESET

PROG RUN

POWER

BRAKE

WARNING

HELP

123

456

987

CLEAR

SmartPAC 2

CAMBIE

AL ESPANOL

CLEAR key

The CLEAR key is in the lower left hand corner of the number keys. Use the CLEAR key to

delete characters when you are entering a number or name. You also use the CLEAR key as

directed in other procedures, such as deleting a tool.

Honeywell SmartPAC 2 - Clear Key