SmartPAC 2 with WPC Integration 1126800
Installing SmartPAC 2 and WPC Chapter 2 page 79
11. Make all the necessary conduit connections to ensure NEMA 12 protection.
SmartPAC 2 is rated NEMA 12 (protected against dust and oil). Be sure to label all
wires in a way consistent with your press’s electrical prints.
Connecting SmartPAC 2 to a Network
Before you can connect SmartPAC 2 to a computer network, your network administrator
must make the necessary connections and settings.
The Ethernet cable plugs into the Ethernet connector on the SmartPAC 2 PC board (see
Figure 2 - 39, page 162,).
NOTICE
SETTING STATIC IP ADDRESS
SmartPAC 2 comes from the factory set up for a Dynamic Host Configuration Protocol
(DHCP) network, which automatically assigns IP addresses. If your network requires static
IP addresses, have your network administrator contact Wintriss Tech Support for assistance
in setting up SmartPAC 2 with a static IP address. See also “CHANGE NETWORK
SETTINGS” in the Initialization chapter, page 262.
To Next Page
Loading...
Need help?
General
