SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Initialization Mode Chapter 4 page 229
5. Repeat steps 2 through 4, for the user inputs you will use.
6. When you are completely done, press RESET twice to return to the Main Initialization
menu.
Press Parameters
(INITIALIZATION – PRESS CONTROL – PRESS PARAMETERS)
Figure 4 - 25. Press Control Parameter Menu
You can set the parameters shown. Highlight the value of the item you want to change and
press ENTER. An entry box appears. Key in the value. Press RESET. For instructions, see
the sections indicated:
Stop Limit, next section
Using Auto Carry-up, page 235
Setting Clutch and Counterbalance Air Pressure Limits, page 238
Setting Shutdown and Flywheel Timer Limits (Optional) , page 239
Setting the ACTS Angle (Optional) , page 240
Initialize Parameters, page 241
To Next Page
Loading...
Need help?
General
