SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Run Mode Chapter 6 page 377
Operating the Press in Continuous On Demand
Mode
DANGER
!
IMPROPER SAFEGUARDING
Ensure that the machine guarding system is installed and maintained according to OSHA
standard 1910.217, ANSI B11.1, ANSI B11.19 and any other regulations and standards that
apply. Ensure that guarding is properly installed to prevent access to the machine over,
under or around any guarding device.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
PRESS STARTING UNEXPECTEDLY
Ensure that light curtains and other safeguards are properly installed and operating to
protect operators when using Continuous on Demand mode, in which a stroke can occur
unexpectedly.
Failure to comply with these instructions will result in death or serious injury.
For information on using this mode, contact Wintriss Tech Support.
To set Prior Act timing for continuous on demand, see “Switch 5 – Prior Act Timing for
Automatic Single Stroke and Continuous on Demand,” page 245.
To Next Page
Loading...
Need help?
General
