SmartPAC 2 with WPC Integration 1126800
SmartPAC 2 Keyboard, Displays Chapter 3 Page 187
and Operating Modes
Selecting an Item on a Display
NOTICE
SELECT = HIGHLIGHT + ENTER
When this manual says “select,” it means highlight the item and press ENTER.
Figure 3 - 16. “ENABLE SENSORS” Is Highlighted in Main Run Menu
To select an item on a menu, use the cursor keys to move the highlight bar until it highlights
the item you want. Then press ENTER.
Highlight the appropriate selection, and then press ENTER. SmartPAC 2 goes to the display
you want, where you can make another selection or make a setting. In each display a message
tells you what to do.
To Next Page
Loading...
Need help?
General
