SmartPAC 2 with WPC Integration 1126800
Installing SmartPAC 2 and WPC Chapter 2 page 133
7. Power down the press and press control. Replace the fuse you removed in step 5.
8. Power up the press and press control. Make sure the press is still in Inch mode. Push the
RUN/INCH buttons briefly. The ram should move.
• If the ram moves, go on to the next test.
• If the ram does not move, check the wiring and correct any problems. Power up the
press and control. Push the RUN/INCH buttons again. If the ram still does not move,
contact Wintriss Tech Support.
To Next Page
Loading...
Need help?
General
