SmartPAC 2 with WPC Integration User Manual 1126800
Glossary page 463
cursor keys used to move the selection bar over the item on the display to be
selected; also used to make certain programming and adjusting
entries, and to select alphabetic characters and special symbols
when naming the press, tools, cam channels, and sensors
depth penetration factor measurement of how far an object, like an operator's hand, can
move through the light curtain before the light curtain reacts
display the screen on the SmartPAC 2 that displays text and graphics,
used along with the keyboard to make and adjust settings, to
load tool numbers, and to view diagnostic messages
dual diverse redundancy the latest technology in maintaining optimum clutch/brake
control and operator safety, where both of the micro-processor
systems ("dual micro-processors") function independently of
each other, have separate power supplies, and provide separate
information to the operator
Dual Safety Valve controls the air flow that operates the clutch and brake of the
press
dwell duration time how long the cam channel and/or sensor are expected to stay
activated
emergency stop signal sent to the press as soon as a malfunction occurs; should
be used when the operator wants the press to stop immediately
enable mode ability to activate or deactivate sensors connected to the die
protection mode; see also manual enable; auto enable by tool;
and auto enable by sensor
ENTER key used after highlighting a selection or keying in a value on the
display
fault (error) message diagnostics that indicate why the press was stopped, identify the
problem, and suggest how to correct
flywheel timer proper setting of this WPC feature prohibits starting the motor in
the reverse direction or activating the Bar mode while the
flywheel is still turning
function keys periodically used to perform certain tasks in SmartPAC; the
message on the LCD display will identify the specific function
key number to depress (from F1 to F8)
good parts counter increments only "good" parts if the die protection and/or tonnage
monitoring option does not generate a fault
To Next Page
Loading...
Need help?
General
