SmartPAC 2 with WPC Integration User Manual 1126800
Glossary page 465
messaging sending e-mails from SmartPAC 2 to pagers, text-enabled cell
phones and e-mail accounts; set up in SmartView.
Micro-inch amount of time in milliseconds that the Dual Safety Valve is
open when WPC's "Micro-inch" feature is enabled, where the
operator determines how long the ram will travel when the
RUN/INCH switches on the operator station are pushed; this
feature is ideal for high-speed and/or short stroke presses
N/C (normally closed) when the sensor circuit to the die protection control is closed to
ground in its normal state
N/O (normally open) when the sensor circuit to the die protection control switches
from open to closed to ground
NEMA 12 rating indicating that the control is protected against dust and oil;
imperative to use conduit of this same rating and make proper
connections to ensure NEMA 12 protection with the enclosure
ninety (90)° stop-time test test that is required in order to set the proper safety distance for
personnel guarding devices including light curtains, two-hand
controls, and type-B movable barriers. This test is done at the
press's most critical stopping point; the worst case scenario
occurs halfway on the down stroke at 90° while the press is
running in continuous that WPC can check stopping time at that
critical crankshaft angle, and provide the T
s
value referenced in
ANSI B11.1 1988.
number keys used to input numeric values, such as counter presets or tool
numbers
object sensitivity smallest diameter object that a light curtain will detect anywhere
in its field
ON-OFF setting stroke angle settings where the cam channel and/or sensor is to
turn ON (actuate) and turn OFF (deactivate)
OSHA stands for Occupational Safety and Health Administration,
which governs regulations pertaining to presence-sensing
devices for point-of-operation guarding on mechanical power
presses
To Next Page
Loading...
