1126800 SmartPAC 2 with WPC Integration
page 468 Glossary
stop types ability to set the way the control stops the press for a
malfunction
stopping angle crankshaft rotation angle that it takes for the press to stop;
stopping position in degrees minus the crankshaft position when
the dual safety valve (DSV) is closed; useful when setting up die
protection system
stopping time how long it takes the crankshaft to stop moving after the Dual
Safety Valve (DSV) deactivates
strokes counter increments each press cycle
suppressor reduces or eliminates electrical noise
timing “ON” and “OFF” settings for sensors and/or cam channels
tool name alpha-numeric designation linked to the tool number which aids
in easier identification
tool number a numeric value assigned to keep track of all settings made
Tool Template a tool on the Tool Manager list that you can use to make
repetitive tool programming easier. Program the Tool Template
with the programming items that are the same on several tools.
Then use the Tool Template as the basis for programming new
tools. Any tool that you name “Tool Template” will serve as the
template.
top stop signal which allows the press to stop at top of stroke (0°); used
when an emergency-stop setting might cause the press to stick
on bottom, and when one hit after a malfunction will not damage
the die or press
top stop constant used to accommodate a press automation function at WPC;
feature that works best on presses that have speed ranges of
several hundred to over a thousand strokes per minute (see
Chapter 4)
total hits counter increments all hits on a tool; if the tool number is loaded again
after other tools are used, the counter starts counting from the
last recorded number for the previous job; useful for deciding
when a tool needs regrinding
USB stands for Universal Serial Bus, a computer term. SmartPAC 2
has a USB connector at J117 on the PC board. You can plug in
a mouse, keyboard or “USB disk” to perform different functions.
To Next Page
Loading...
