3 Apply the changes.
PPDS Emulation
This setting determines if the printer can recognize and use the PPDS data stream.
1 Enter the Configuration Menu, and then select PPDS Emulation.
2 Select a setting.
3 Apply the changes.
Download Emuls
This menu appears only if at least one download emulator (DLE) is installed. The default setting is Disable. All download
emulators are automatically re‑enabled after two PORs.
Enter the Configuration Menu, and then select Download Emuls.
Safe Mode
When Safe Mode is enabled, the printer operates in a special limited mode with as much functionality as possible
despite known issues. For more information about Safe Mode and the Safe Mode print behavior, see
“Entering Safe
Mode (EverReady Mode)” on page 212.
1 Enter the Configuration Menu, and then select Safe Mode.
2 Select a setting, and then apply the changes.
3 Reset the printer.
Energy Conserve
This setting controls which values appear on the Power Saver menu.
1 Enter the Configuration Menu, and then select Energy Conserve.
2 Select a setting.
3 Apply the changes.
Fax Low Power Support
This setting allows you to select the power settings for fax.
• Auto—Determines whether the printer supports the fax portion of the low power architecture
• Permit Sleep—Allows the fax chip to enter the low power mode
• Disable Sleep—Does not allow the fax chip to enter the low power mode
1 Enter the Configuration Menu, and then select Fax Low Power Support.
2 Select a setting.
3 Apply the changes.
4021, 7421
Service menus
205
To Next Page
Loading...
