9 Remove the clip (C), remove the front belt cover, and then remove the belt.
10 Remove the screw (D), and then remove the belt from the bracket.
Installation note: To ensure that the front and rear brackets are level, place them at their lowest position before
installing the belts on the gears.
Staple finisher elevator gears removal
1 Remove the bin. See “Staple finisher bin removal” on page 232.
2 Remove the rear cover. See “Staple finisher rear cover removal” on page 230.
3 Remove the front cover. See “Staple finisher front cover removal” on page 229.
4021, 7421
Repair information
274
To Next Page
Loading...
