14 Remove the two clips (C), and then remove the gears.
Staple finisher upper exit roller assembly removal
1 Remove the front cover. See “Staple finisher front cover removal” on page 229.
2 Remove the rear cover. See “Staple finisher rear cover removal” on page 230.
3 Remove the top cover. See “Staple finisher top cover removal” on page 231.
4 Remove the controller board. See “Staple finisher controller board removal” on page 244.
5 Remove the controller board holder. See “Staple finisher controller board holder removal” on page 245.
6 Remove the exit motor bracket. See “Exit motor bracket removal” on page 277.
7 Remove the exit guide lift cam. See “Staple finisher exit guide lift cam removal” on page 279.
8 Remove the upper exit roller drive gear shaft. See “Staple finisher upper exit roller drive gears removal” on
page 280.
9 Remove the upper exit actuator. See “Staple finisher upper exit actuator removal” on page 285.
4021, 7421
Repair information
305
To Next Page
Loading...
