Bifold skew adjustment
Perform this procedure when:
• Reinstalling the booklet maker aligner assembly.
• The fold skew exceeds the tolerance of +/‑ 1 mm.
1 Send a bifold print job.
2 Unfold the paper with the ridge facing up.
A
A
3 Confirm the skew (A) by measuring the length of edges A1 and A2. If A1‑A2 exceeds +/‑ 1 mm, then proceed with
the rest of the steps.
A
A1
A2
A
4 Pull out the booklet maker from the finisher, and then loosen the two screws (B).
B
4021, 7421
Repair information
227
To Next Page
Loading...
