9 Dislodge the motor bracket from the finisher, and then remove the gear.
10 Remove the pin from the shaft.
SHPF paddle motor bracket removal
Note: This part is not a FRU.
1 Remove the front door. See “SHPF front door removal” on page 336.
2 Remove the top inner cover. See “SHPF top inner cover removal” on page 336.
3 Disconnect the two cables (A).
4 Remove the three screws (B), and then remove the motor bracket.
4021, 7421
Repair information
383
To Next Page
Loading...
