The idler rollers raise, and while the first stack is being stapled, the second sheet is positioned over the first sheet.
The idler rollers lower, and then the two sheets are fed to the compiler assembly. At the same time, the first stack is
fed to the elevator bin. Unlike the first and second sheets, the succeeding sheets of the second stack are individually
fed to the compiler assembly.
The succeeding jobs are done in the same manner as the first and second stacks.
SHPF compiler section exit
After alignment or stapling, the motor (SHPF compiler pre-eject) controls the middle aligner to push the stack to the
eject clamp. The motor (SHPF compiler eject) controls the eject clamp to push the stack to the elevator bin.
4021, 7421
Appendix C: Theory of operation
662
To Next Page
Loading...
