Lexmark MS911 - Staple Finisher Tamper Racks Removal

Staple finisher tamper racks removal
1 Remove the front cover. See “Staple finisher front cover removal” on page 229.
2 Remove the rear cover. See “Staple finisher rear cover removal” on page 230.
3 Remove the top cover. See “Staple finisher top cover removal” on page 231.
4 Remove the bin. See “Staple finisher bin removal” on page 232.
5 Remove the left inner cover. See “Staple finisher left inner cover removal” on page 233.
6 Remove the bin stack height assembly. See “Staple finisher bin stack height assembly removal” on page 233.
7 Remove the controller board. See “Staple finisher controller board removal” on page 244.
8 Remove the controller board holder. See “Staple finisher controller board holder removal” on page 245.
9 Remove the exit motor bracket. See “Exit motor bracket removal” on page 277.
10 Remove the upper guide. See “Staple finisher upper guide removal” on page 287.
11 Remove the exit guide lift cam. See “Staple finisher exit guide lift cam removal” on page 279.
12 Remove the upper exit roller drive gear shaft. See “Staple finisher upper exit roller drive gears removal” on
page 280.
13 Remove the upper exit actuator. See “Staple finisher upper exit actuator removal” on page 285.
14 Remove the upper exit roller assembly. See “Staple finisher upper exit roller assembly removal” on page 305.
15 Remove the tamper and aligner assembly. See “Staple finisher tamper and aligner assembly removal” on page
311.
4021, 7421
Repair information
315