11 Remove the guide (A), and then remove the clip (B).
12 Move the guide to release the bushing, and then remove the roller (C).
Staple finisher upper exit roller belts and gear removal
1 Remove the front cover. See “Staple finisher front cover removal” on page 229.
2 Remove the rear cover. See “Staple finisher rear cover removal” on page 230.
3 Remove the top cover. See “Staple finisher top cover removal” on page 231.
4 Remove the controller board. See “Staple finisher controller board removal” on page 244.
5 Remove the controller board holder. See “Staple finisher controller board holder removal” on page 245.
6 Remove the exit motor bracket. See “Exit motor bracket removal” on page 277.
7 Remove the exit guide lift cam. See “Staple finisher exit guide lift cam removal” on page 279.
8 Remove the upper exit roller drive gear shaft. See “Staple finisher upper exit roller drive gears removal” on
page 280.
9 Remove the upper exit actuator. See “Staple finisher upper exit actuator removal” on page 285.
10 Remove the upper exit roller assembly. See “Staple finisher upper exit roller assembly removal” on page 305.
11 Remove the upper exit roller. See “Staple finisher upper exit roller removal” on page 308.
4021, 7421
Repair information
309
To Next Page
Loading...
