• Cancel the print job.
Load Multipurpose Feeder with [paper type] [paper size] [paper orientation]
Try one or more of the following:
• Load the feeder with the correct size and type of paper.
• From the control panel, touch one of the following:
– Prompt each page, paper loaded or Do not prompt, paper loaded—To clear the message and continue printing.
– Automatically select paper—To use the paper loaded in the tray.
– Reset active bin—To reset the active bin for a linked set of bins.
• Cancel the print job.
Load staples
Try one or more of the following:
• Replace or insert the staple cartridge in the finisher.
For instructions on inserting or replacing a staple cartridge in the finisher, touch More information on the printer
control panel.
• From the printer control panel, touch Continue to clear the message and continue printing.
• From the printer control panel, touch Cancel job to cancel the print job.
Load staples [G11, G12]
Try one or more of the following:
• Replace or insert the staple cartridge into the finisher.
For instructions on replacing or inserting the staple cartridge into the finisher, touch More information on the
control panel.
• From the control panel, touch Continue to clear the message and continue printing.
• Cancel the print job.
[x] maintenance kit very low [80.xy]
You may need to replace the maintenance kit very soon. For more information, go to the Lexmark support Web site at
http://support.lexmark.com or contact customer support, and then report the message.
If necessary, touch Continue to clear the message and continue printing.
Memory full [38]
Try one or more of the following:
• From the control panel, touch Cancel job to clear the message.
• Touch Reset active bin to reset the active bin for a linked set of bins.
• Install additional printer memory.
4021, 7421
Diagnostic information
42
To Next Page
Loading...
