Lexmark MS911 - Sensor (SHPF Rear Tamper Home) Removal; Motor (SHPF Elevator) Removal

Sensor (SHPF rear tamper home) removal
1 Remove the rear cover. See “SHPF rear cover removal” on page 339.
2 Release the latch (A), and then remove the sensor.
3 Disconnect the cable from the sensor.
Motor (SHPF elevator) removal
1 Remove the rear cover. See “SHPF rear cover removal” on page 339.
2 Disconnect the two cables (A).
4021, 7421
Repair information
359