16 Remove the cables (B) from the holder.
17 From the top, remove the aligner.
Staple finisher tamper drive gears removal
1 Remove the front cover. See “Staple finisher front cover removal” on page 229.
2 Remove the rear cover. See “Staple finisher rear cover removal” on page 230.
3 Remove the top cover. See “Staple finisher top cover removal” on page 231.
4 Remove the bin. See “Staple finisher bin removal” on page 232.
5 Remove the left inner cover. See “Staple finisher left inner cover removal” on page 233.
6 Remove the bin stack height assembly. See “Staple finisher bin stack height assembly removal” on page 233.
7 Remove the controller board. See “Staple finisher controller board removal” on page 244.
4021, 7421
Repair information
313
To Next Page
Loading...
