4 Disconnect the cable (B), and then remove the assembly.
Staple finisher interface board removal
1 Remove the front cover. See “Staple finisher front cover removal” on page 229.
2 Remove the staple unit. See “Staple finisher staple unit removal” on page 260.
3 Remove the staple unit carriage assembly. See “Staple finisher staple unit carriage assembly removal” on page
261.
4 Disconnect all cables from the board.
5 Release the two latches (A), and then remove the board.
4021, 7421
Repair information
262
To Next Page
Loading...
