Lexmark MS911 - Replace Missing Waste Toner Bottle [82.Xy]; Replace Missing Cartridge [31.Xy]; Replace Paper Pick Rollers in [Paper Source], Use Parts and Instructions in Tray 1 or Tray 2 Compartment [80]; Replace Photoconductor, 0 Pages Remain [84.Xy]

Replace missing waste toner bottle [82.xy]
Install the missing waste toner bottle to clear the message. For more information, see the instruction sheet that came
with the supply.
Replace missing cartridge [31.xy]
Install the missing cartridge to clear the message.
Replace paper pick rollers in [paper source], use parts and instructions in tray 1 or
tray 2 compartment [80]
Try one or more of the following:
• Replace the pick rollers, and then touch Rollers replaced on the control panel to clear the message and continue
printing.
• Touch Continue and replace later (Jams may continue to occur) to ignore the message and continue printing.
Replace photoconductor, 0 pages remain [84.xy]
Replace the photoconductor unit to clear the message and continue printing.
Replace unsupported cartridge [32.xy]
Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For more
information, see the instruction sheet that came with the supply or see the “Replacing supplies” section of the User’s
Guide.
Note: If you do not have a replacement cartridge, then see the “Ordering supplies” section of the User’s Guide or
visit
www.lexmark.com.
Replace unsupported photoconductor [32.xy]
Remove the photoconductor unit, and then install a supported one to clear the message and continue printing.
Replace waste toner bottle [82.xy]
Replace the waste toner bottle to clear the message.
Restore held jobs?
Try one or more of the following:
• From the printer control panel, touch Restore to restore all held jobs stored in the printer hard disk.
• From the printer control panel, touch Do not restore if you do not want to restore any of the print jobs.
4021, 7421
Diagnostic information
47