Lexmark MS911 - Staple Finisher bin Stack Height Actuator Removal

3 Remove the bin stack height assembly. See “Staple finisher bin stack height assembly removal” on page 233.
4 Disconnect the cable (A).
5 Remove the two screws (B), and then remove the solenoid.
Staple finisher bin stack height actuator removal
1 Remove the bin. See “Staple finisher bin removal” on page 232.
2 Remove the left inner cover. See “Staple finisher left inner cover removal” on page 233.
3 Remove the bin stack height assembly. See “Staple finisher bin stack height assembly removal” on page 233.
4 Remove the bin stack height solenoid. See “Staple finisher bin stack height solenoid removal” on page 235.
4021, 7421
Repair information
236