Installation notes:
a Position both aligners at the middle.
b Install the shaft, with the metal portion of the aligners hanging down.
SHPF booklet maker pre-feed roller removal
1 Remove the front door. See “SHPF front door removal” on page 336.
2 Remove the top inner cover. See “SHPF top inner cover removal” on page 336.
3 Remove the rear cover. See “SHPF rear cover removal” on page 339.
4 From the front, remove the clip (A), and then remove the bearing.
4021, 7421
Repair information
421
To Next Page
Loading...
