Lexmark MS911 - Staple Finisher Left Inner Cover Removal; Staple Finisher Lower Exit Roller Paddles Removal; Staple Finisher bin Stack Height Assembly Removal

Staple finisher left inner cover removal
1 Remove the bin. See “Staple finisher bin removal” on page 232.
2 Remove the two screws (A), and then remove the cover.
Staple finisher lower exit roller paddles removal
1 Remove the bin. See “Staple finisher bin removal” on page 232.
2 Remove the four paddles (A).
Staple finisher bin stack height assembly removal
Note: This part is not a FRU. Perform these steps to access the FRUs attached to this part.
1 Remove the bin. See “Staple finisher bin removal” on page 232.
2 Remove the left inner cover. See “Staple finisher left inner cover removal” on page 233.
4021, 7421
Repair information
233