Lexmark MS911 - Sensor (Booklet Maker Fold Exit) Removal

8 Remove the clip (D).
9 Disconnect the cable (E), and then remove the diverter.
Sensor (booklet maker fold exit) removal
1 Remove the front cover. See “Booklet maker front cover removal” on page 456.
2 Remove the trifold guide motor bracket. See “Trifold guide motor bracket removal” on page 489.
3 Remove the trifold gate actuator. See “Trifold gate actuator removal” on page 490.
4 Remove the trifold knife assembly. See “Trifold knife assembly removal” on page 504.
5 Remove the trifold diverter. See “Trifold diverter removal” on page 514.
4021, 7421
Repair information
515