8 Remove the controller board holder. See “Staple finisher controller board holder removal” on page 245.
9 Remove the exit motor bracket. See “Exit motor bracket removal” on page 277.
10 Remove the upper guide assembly. See “Staple finisher upper guide removal” on page 287.
11 Remove the exit guide lift cam. See “Staple finisher exit guide lift cam removal” on page 279.
12 Remove the upper exit roller drive gear shaft. See “Staple finisher upper exit roller drive gears removal” on
page 280.
13 Remove the upper exit actuator. See “Staple finisher upper exit actuator removal” on page 285.
14 Remove the upper exit roller assembly. See “Staple finisher upper exit roller assembly removal” on page 305.
15 Remove the tamper and aligner assembly. See “Staple finisher tamper and aligner assembly removal” on page
311.
16 Remove the four screws (A), and then remove the motor brackets.
17 Remove the two gears (B).
4021, 7421
Repair information
314
To Next Page
Loading...
