6 Remove the exit motor bracket. See “Exit motor bracket removal” on page 277.
7 Remove the upper guide. See “Staple finisher upper guide removal” on page 287.
8 Remove the lower guide. See “Staple finisher lower guide removal” on page 291.
9 Remove compiler feed roller guide. See “Staple finisher compiler feed roller guide removal” on page 293.
10 Remove compiler feed roller shaft assembly. See “Staple finisher compiler feed roller shaft assembly removal” on
page 296.
11 Remove the two clips (A), and then slide the bushings.
12 Remove the roller (B). Also remove the other roller.
13 Remove the two compiler feed roller belts (C).
4021, 7421
Repair information
299
To Next Page
Loading...
