# Part
1 Motor (SHPF elevator)
2 Motor (SHPF elevator bin stack height)
3 Sensor (SHPF elevator bin full) (booklet maker installed)
4 Sensor (SHPF elevator bin full) (booklet maker not installed)
5 Elevator bin full position (booklet maker not installed)
6 Elevator bin full position (booklet maker installed)
7 Elevator bin home position
8 Top bin
Elevator bin stack height detection
Each time paper is fed out to the bin, the motor (SHPF elevator bin stack height) lowers the elevator bin stack height
fingers to come into contact with the edge of the stack. If the fingers are unable to lower and the sensors (SHPF elevator
bin stack height, front and rear) are blocked, then the bin lowers until the two sensors are unblocked.
4021, 7421
Appendix C: Theory of operation
664
To Next Page
Loading...
