• Area H10
6 Push the booklet maker back into place.
7 Close door H.
8 Open door C, and then remove the jammed paper.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
Notes:
• Make sure that door C does not hit any cable attached to the printer.
• Make sure that all paper fragments are removed.
• If the 3000‑sheet tray is installed, then slide the tray to the right to open the door.
9 Close door C.
4021, 7421
Diagnostic information
72
To Next Page
Loading...
