Lexmark X862de - Page 116

2-16 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
283.01
Paper jam
Check area
G2
Sensor (buffer path) on jam B Sensor (buffer path) is not turned on within the
specified time after the sensor (finisher media
entrance is turned on.
At this time, the sensor (diverter gate) is turned on.
Refer to the Options Service Manual.
283.02
Paper jam
Check areas
G2, G3
Sensor (buffer path) static
jam A
Paper remains on the sensor (finisher buffer path).
At this time, both sensor (diverter gate) and sensor
(finisher media exit) are on state.
Refer to the Options Service Manual.
283.03
Paper jam
Check areas
G2
Sensor (buffer path) static
jam B
Paper remains on the sensor (finisher buffer path).
At this time, the sensor (diverter gate) is on state but
the sensor (finisher media entrance) is turned off.
Refer to the Options Service Manual.
283.04
Paper jam
Check areas
G4
Sensor (buffer path) static
jam C
Paper remains on the sensor (finisher buffer path).
At this time, the sensor (diverter gate) is turned off.
Refer to the Options Service Manual.
284.00
Paper jam
Check area F
Sensor (lower media exit) off
jam A
Sensor (lower media exit) is not turned off within the
specified time after the finisher sensor (lower media
exit) is turned on.
At this time, the sensor (bridge unit media exit) is
turned off.
Refer to the Options Service Manual.
284.01
Paper jam
Check area F
Sensor (lower media exit) on
jam A
Sensor (buffer path) is not turned on within the
specified time after the sensor (finisher media
entrance) is turned on.
At this time the sensor (bridge unit media exit) is
turned on.
Refer to the Options Service Manual.
284.02
Paper jam
Check areas
G2, G3
Sensor (lower media exit) on
jam B
Sensor (buffer path) is not turned on within the
specified time after the sensor (bridge unit media
entrance) is turned on.
At this time, the sensor (finisher media entrance) is
turned on.
Refer to the Options Service Manual.
284.03
Paper jam
Check area
G2
Sensor (lower media exit) on
jam C
Finisher sensor (lower media exit) not turned on
within the specified time after the sensor (buffer
path) is turned on.
Refer to the Options Service Manual.
284.04
Paper jam
Check area H
Sensor (lower media exit) off
jam B
Finisher sensor (lower media exit) not turned off
within the specified time after the finisher sensor
(lower media exit) on.
At this time, the sensor (finisher media entrance) is
turned on.
Refer to the Options Service Manual.
Error code or
message
Error contents Description/Action