Lexmark X862de - Page 118

2-18 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
287.06
Paper jam
Check areas
G1, G3
Sensor (upper media exit)
static jam B
Paper remains on the sensor (upper media exit).
At this time, the sensor (bridge unit media exit) is off
state but the finisher sensor (finisher media
entrance) is turned on.
Refer to the Options Service Manual.
287.07
Paper jam
Check area
G1
Sensor (upper media exit)
static jam C
Paper remains on the sensor (upper media exit).
At this time, both sensor (bridge unit media exit) and
sensor (finisher media entrance) are turned off.
Refer to the Options Service Manual.
288.00
Paper jam
Check area F
Sensor (diverter gate) on jam Sensor (diverter gate) is not turned on within the
specified time after the sensor (bridge unit media
exit) is turned on.
Refer to the Options Service Manual.
288.01
Paper jam
Check area F
Sensor (diverter gate) static
jam (to top bin) A
Paper remains on the sensor (diverter gate) when
the finisher is in the upper bin exit mode.
At this time the sensor (bridge unit media exit) is
turned on.
Refer to the Options Service Manual.
288.02
Paper jam
Check areas
G2, G3
Sensor (diverter gate) static
jam (to top bin) B
Paper remains on the sensor (diverter gate) when
the finisher is in the upper bin exit mode.
At this time, the sensor (finisher media entrance) is
turned on, but the sensor (bridge unit media exit) is
turned off.
Refer to the Options Service Manual.
288.03
Paper jam
Check area
G1
Sensor (diverter gate) static
jam (to top bin) C
Paper remains on the sensor (diverter gate) when
the finisher is in the upper bin exit mode.
At this time, both sensor (finisher media entrance)
and sensor (bridge unit media exit) are turned off.
Refer to the Options Service Manual.
288.04
Paper jam
Check area F
Sensor (diverter gate) static
jam (to stacker bin) A
Paper remains on the sensor (diverter gate) when
the finisher is in the stacker bin exit mode.
At this time, the sensor (bridge unit media exit) is
turned on.
Refer to the Options Service Manual.
288.05
Paper jam
Check areas
G2, G3
Sensor (diverter gate) static
jam (to stacker bin) B
Paper remains on the sensor (diverter gate) when
the finisher is in the stacker bin exit mode.
At this time, the sensor (finisher media entrance) is
turned on, but the sensor (bridge unit media exit) is
turned off.
Refer to the Options Service Manual.
288.06
Paper jam
Check area
G2
Sensor (diverter gate) static
jam (to stacker bin) C
Paper remains on the sensor (diverter gate) when
the finisher is in the stacker bin exit mode.
At this time, both sensor (finisher media entrance)
and sensor (bridge unit media exit) are turned off.
Refer to the Options Service Manual.
Error code or
message
Error contents Description/Action