Mitel 430 - Page 254

Call routing
254
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Settings at the gateway PINX (PINX 2)
Specifying the transit route
The transit route is specified using the Transit route setting. If an incoming call has a
phone number with numbering plan identifier NPI = E.164, it will be forwarded via the
defined route. This route leads to the public network (see also page 241
).
Tab. 73 Settings for the break-out routing at the gateway PINX
(PINX 2 in Zurich)
• Network interfaces Network interfaces of this trunk group
• Network type Private
• Protocol QSIG or QSIG / PSS1 ISO
• Automatic CLIP yes
Parameter Parameter value
Transit route:
• Route 4 (this route is used for the transit routing)
Route 4:
• Name Zurich, exchange
• Trunk group 1
• Numbering plan identifier (NPI) E.164
• Type of number (TON) Unknown
Trunk group 1:
• Name Zurich, ISDN exchange
• Network interfaces Network interfaces of this trunk group
• Network type Public
• Protocol DSS1
• Create CLIP number automatically Activated
Parameter Parameter value