EasyManuals Logo

NetCommWireless NTC-400 Series User Manual

NetCommWireless NTC-400 Series
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
NTC-400 Series
103 of 361
© NetComm Wireless 2018
3.3.3.2 Setup Advanced Configuration
Figure 120 – Advanced Configuration
Item Notes Description
Regulatory
Domain
This value is
determined by the
region of sale.
This displays the range of available radio channels that may be used for WiFi. The
permissible channels depend on the Regulatory Domain.
Beacon Interval 100 Shows the time interval between each beacon packet broadcasted.
The beacon packet contains the SSID, Channel ID and Security settings.
DTIM Interval 3 A DTIM (Delivery Traffic Indication Message) is a countdown informing clients of the next
window for listening to the broadcast message. When the device has buffered the
broadcast message for associated client, it sends the next DTIM with a DTIM value.
RTS Threshold 2347 RTS (Request To Send) Threshold means when the packet size is over the setting value,
then active RTS technique. RTS/CTS is a collision avoidance technique. If RTS is set to
2347, it is never activated.
Fragmentation 2346 Wireless frames can be divided into smaller units (fragments) to improve performance in
the presence of RF interference at the limits of RF coverage.
WMM Enabled by default. WMM (Wi-Fi Multimedia) can help control latency and jitter when transmitting
multimedia content over a wireless connection.
Short GI Default setting:
400ns
Short GI (Guard Interval) is defined to set the send interval between each packet. Note
that a lower value could increase not only the transition rate but also the error rate.
TX Rate Default setting: Best The data transmission rate. When Best is selected, the device will choose an appropriate
data rate according to the signal strength.
RF Bandwidth Default setting: Auto The setting of RF bandwidth limits the maximum data rate.
Transmit
Power
Default setting: 100% Controls the transmission power of the wireless radio.
5G Band
Steering
Disabled by default. When a wireless client connects to the 2.4G WiFi network, the router will send the client
to the 5GHz network automatically if the client is capable of accessing it.

Table of Contents

Other manuals for NetCommWireless NTC-400 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NetCommWireless NTC-400 Series and is the answer not in the manual?

NetCommWireless NTC-400 Series Specifications

General IconGeneral
BrandNetCommWireless
ModelNTC-400 Series
CategoryNetwork Router
LanguageEnglish